Ah, the great debate: letting the yellow mellow versus flushing every time. Yes, this is a gross topic, but also perhaps an important one as we all consider how to live a lifestyle that is easier on the planet. Water is a valuable resource that we must treat with respect, and toilets use water, so here we are.
Is there a hard and fast rule to follow for flushing your toilet in a way that is best for the planet? Does skipping a flush here and there really save you money and help ease the burden we put on Mother Nature? And just how wasteful is waste management? Here’s a look at how often you really need to flush the toilet, and why.
“If it’s yellow, let it mellow”
And “if it’s brown, flush it down.”
This little rhyme is well known to many of us, whether from childhood, camp, or media. But not everyone follows the mantra and some are staunchly against it. Reasons given for flushing every time include hygiene and respect, as well as making cleaning easier. The truth, though, is that it’s not always more hygienic to flush every time!
Let’s conquer some myths about the porcelain throne.
#1. Letting it mellow spreads germs
Leaving pee in the bowl instead of flushing it away seems gross and unsanitary to some. However, the science says that flushing every time actually spreads more germs. Yup.
Meet ‘toilet plume’ – the spray caused by that blast of water when flushing. This spray, which is a mix of fresh water and urine, leads to droplets floating about your bathroom and ending up on your clothing and skin.
Your best bet? Flush only when needed and always close the lid before flushing. Added bonus: closing the lid and letting it mellow also means less odor.
#2. Not flushing saves nine gallons of water.
Most people pee 6 or 7 times a day, so if you flushed every time and each flush used 9 gallons, that could mean using around 60 gallons of water every day just to flush. And if you have a nervous bladder, are pregnant, or have other reasons why you might pee more often, you could be using a lot of water every day if you flush each time.
Not so fast, though. Sure, not flushing saves water… but it’s very unlikely you’re using nine gallons each time you press that lever. Only very old, inefficient toilets use more than 7 gallons of water per flush. Most modern toilets only use about 1.5 gallons per flush, and even most older toilets use just 3-5 gallons. So, the water savings are actually fairly minimal.
In fact, in 1994, the US Environmental Protection Agency brought in a requirement for all toilets to use a maximum of 1.6 gallons of water for each flush. There are also an increasing number of WaterSense toilets that use 1.28 gallons per flush or less (while still matching or exceeding performance of toilets with higher flush volumes). WaterSense toilets have to meet rigorous standards and often come with rebates and vouchers to lower their cost.
Of course, not flushing does save some water. So, even if you have a highly water-efficient toilet that uses just 1.28 gallons per flush, that could still mean you’d save potentially 1400 gallons of water a year if you only flushed every other time you peed (3 fewer flushes a day, for 365 days).
There are other ways to save water though, albeit ones that feel rather removed. For instance, it takes around 660 gallons of water to produce an average 1/3 pound hamburger. So, even having a Meatless Monday every week would save some 34,320 gallons of water each year. And how about your jeans? Yup. Producing the average pair of denim jeans requires around 2,900 gallons of water, and that’s before you’ve even washed them!
So, yes, not flushing every time will save water, and every little bit helps, but don’t let that fool you into complacency in other more water-intensive areas of life.
#3. Not flushing saves a ton of money!
I hate to break it to you, but not flushing isn’t going to pay for your next vacation. At best, you might save enough on your water utility bill to cover the server’s tip on a poolside cocktail.
The average cost of a gallon of water is around 0.18 cents in the US. Assuming each flush uses 1.5 gallons and that you skip the flush three times a day, that amounts to around $2.95 saved each year.
Now, this will vary from state to state and even city to city. For instance, if you live in Florida, your savings will likely be much lower because water costs less. If you live in any of the following places though, you’ll likely save more by letting it mellow as these are the 10 states with the highest water rates:
- West Virginia
- New Jersey
#4. Pee is sterile
Urine is quite surprisingly clean, but it’s not entirely sterile. Compared to saliva, urine contains relatively few microorganisms, with barely any while it’s in the bladder itself. However, urine picks up bacteria and other microbes as it passes through your system and into the bowl.
So, pee isn’t pristine, but it’s also not terribly germ-riddled. And there’s a good chance your municipal water has some residual germ-killing chlorine (unless you use a home water filter system). All of this means it’s fine to let it mellow for a few hours, ideally covered, before flushing the next time someone uses the facilities. If you have a urinary tract infection though, it’s a good idea to flush each time, especially if you share the bathroom with other people.
#5. Letting pee sit makes it harder to clean your toilet
This is the best reason I can find for flushing every time you pee. Why? Because the combination of urine and hard water (i.e., water that contains a lot of minerals), if left to sit for a few hours, can create a crusty deposit on the side of the bowl over time. Those stubborn rings might not seem all that bad, but if you end up using harsh chemical cleaners to get rid of them, the environmental impact becomes that much higher.
Thankfully, you have a few options here:
- Install a water softening filtration system
- Don’t let it mellow
- Clean our toilet with milder cleaners at least twice a week, instead of once a week or less.
As we’ve seen, there’s no clear winner in the battle of the flush. Whether you’re feeling mellow or militant about flushing, there’s something to be said for both sides of the argument. Either way, if you don’t have a modern toilet with a high-efficiency flush, it’s time to upgrade or take other steps to curb water usage. This could be as simple as putting a plastic bottle filled with water and a few rocks or pebbles into your cistern, so less water is used per flush.
You might also consider peeing in the shower… though this is one to run by your family and/or housemates first if you don’t live alone.
And if you do decide to upgrade, consider a WaterSense certified toilet, so you can be sure you’re saving water without losing out on performance.